Materials
5x5 card stock (color on both sides)
favorite font stamps
scrap paper
stencils
favorite verse
scissors
clicking pen
thin cloth
small rubber band
Fold card stock in half. Cut about an inch off the bottom. Using your scissors, round the inside corner. Cut a design in the outside edges, making the top slightly shorter than the bottom. If you have design scissors* they work best. Cut the edges of the scrap paper with same design and paste approximately 1 cm from the edge. Using your favorite font stamps, fill the outside edge with a name, "Thank you," "Congrats," or anything you choose. If you do not have stamps, stencils** will work. The final step is embossing. I know that embossers are fairly expensive so I'm going to explain how to emboss without buying. If you wish to emboss*** with an embosser, see below. First things first. You need an embossing pen. Take your clicking pen and disassemble it so that all you have is the shell. Then take your cloth and cover then point with it. Secure tightly with rubber band. Next take a stencil and place over paper in appropriate spot. Using your homemade embossing pen, outline the stencil with a heavy hand. The thinner your cloth, the easier it will be. Do not use the pen without a cloth, though. It will mess up the paper. You can also buy an embossing pen at any Hobby Lobby or Micheal's. After you've done that, simply write out your favorite verse and sign.5x5 card stock (color on both sides)
favorite font stamps
scrap paper
stencils
favorite verse
scissors
clicking pen
thin cloth
small rubber band
*Cut opposite designs on top and bottom. Match the scrap paper with the top design.
**To use stencils requires a bit more work that stamps. You cannot line them up, easily to see if they fit. I recommend using a scrap paper than trying it before putting it on the card. This will help you estimate spacing correctly.
***Manual embosser-place paper on board in the appropriate spot. Place stencil over paper and secure. Using the small embossing pen, outline each stencil with a heavy hand. Using the large pen, stroke inside the top outline to make raised texture.
Crank embosser-place paper on cutting board. Adjust the embossing piece to the appropriate place and set the top board on top of that. Run through the machine.
Sidenote: Technically, embossing is the raising of a surface, but I prefer the impression of a surface instead. You can do whichever you prefer :)